5
Total Control
MRX-4SEN2
Owner’s Manual
Installing the MRX-4SEN2
The MRX-4SEN2 Sensor Extender can be installed almost anywhere in the home.
Once physically installed, it requires
programming by a certified URC integrator
in order to function properly.
Connect the 3.5mm sensor plug to the
rear
of the MRX-4SEN2. When a
change
in
the sensor’s
state
is detected, the MRX-4SEN2 sends a signal to the MRX Advanced
Network System Controller and
triggers
a series of commands.
This home network example showcases a
voltage sensor
connected to the home’s
doorbell
and the
MRX-4SEN2
. Whenever the door bell is
pressed
, a signal is sent
over URC’s RF 2.4GHz to the MRX Advanced Network System Controller. The MRX
unit
triggers
a series of commands or an event to gain your attention. A
programmed event, such as Watch Movie/TV, may pause the movie, mute the audio
and display the front door’s video camera.
