Uponor Smatrix Move, Quick Manual, Page: 5 / 268

UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
5
U P O N O R S M AT R I X M O V E · Q U I C K G U I D E
Q U I C K G U I D E
Quick Guide
N OT E !
This is a quick start guide to serve as a
reminder for experienced installers. We
strongly recommend reading the full
installation and operation manual before
installing the control system.
W
arning
!
Electrical installation and service behind
secured 230 V AC covers must be carried
out under the supervision of a qualified
electrician.
230 V AC
50 Hz
POWER
PUMP P1
In1/In2 ***
In1/In2 ***
In1/In2 **
OUTSIDE *
SENSOR
WATER RETURN ***** WATER IN
HEAT
COLD **
2
4
In2
In1
In1 In2
L N L N
N L N L
ACTUATOR 230 V
Open
Common
Close
CONTACT
Ther ****
230 V 50 Hz
PUMP P2 **
*) The outdoor temperature sensor can be connected to either the controller or to a thermostat (requires antenna A-155).
**) Connect either COLD or PUMP P2 (secondary heating/cooling circuit) to the connection terminal.
***) Select one of the inputs (heating/cooling switch, pump control signal, or immersion thermostat) and set parameter 11 – Wired Input 1 selection, or parameter 12 – Wired
Input 2 Selection, accordingly. The heating/cooling option can only be used in systems without a registered wireless thermostat.
****) Optional temperature limiter connection, fitted with a cable bridgre from the factory. Remove the bridge if a temperature limiter is to be used together with PUMP P1.
*****) Optional return sensor. Can only be used, for boost function, in systems without a registered wireless thermostat.