Adhesive pads
(optional. qty 4)
5/8’’
Wood screws
(qty 8)
Track
Front bumper
Back bumper
Machine screws
(qty 4)
Acorn nuts
(qty 4)
Cord catcher
Mousepad
Keyboard Tray
Palm support
Mechanism
© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Package contents
®
Switch Keyboard Tray
UPL140
Step 1
Take the Track and place underneath your desktop, in order to figure out
where to place it. If there are pre-drilled holes in your desktop, line the track
up with the holes, or you can pre-drill your own 1/8” pilot holes.
Be sure to leave about 1/2” from the front edge of the desk.
Use eight (8) Wood screws to attach the track to the desktop, and one more
screw to attach the rear bumper as shown.
Step 5
Finally, lower the tray, slide it back on the track and install the front
bumper.
Step 2
With the desk right side up, line up the mechanism with the grooves on
the track and slide it in.
Please note: the mechanism will not adjust up or down until the tray
has been attached and the shipping pin is removed (see steps 3 and 4).
Step 3
Attach the tray to the mechanism by lining up the integrated screws on
the bottom of the tray with the holes on the mechanism, and secure by
screwing the 4 acorn nuts in to the underside of the tray.
Step 4
Lift up on the front of the tray and lower the back to relieve pressure on
the shipping pin and remove it.
UPL140/R02
