© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 1
Take the Track and place underneath your desktop, in order to figure out
which size to use (11’’ or 21’’ Track) and where to place it. If there are pre-
drilled holes in your desktop, line the track up with the holes. If there are
not pre-driled holes, drill your own pilot holes
using 1/8’’ diameter drill bit
and drill 1/2’’ deep. Be sure to leave about 1/2” from the front of the desk.
Use eight (8) Wood screws to attach the 21’’ track, and six (6) Wood
screws to attach the 11’’ track to the desktop. Use one (1) more screw to at-
tach the Rear bumper as shown.
Step 2
With the desk right side up, line up the mechanism with the grooves on the
track and slide it in.
Please note: the mechanism will not adjust up or down until the tray has
been attached and the shipping pin is removed (see steps 3 and 4).
Step 3
Attach the tray to the mechanism by lining up the holes in the tray with
the holes on the mechanism, and secure by inserting the four (4) Machine
screws through the holes, and screwing the four (4) Acorn nuts onto them
from below.
UPL127/R03
®
Large Keyboard Tray
UPL127
Caution:
When using screws on a desktop with a center-cut ergo edge, take care to
ensure that the screw is not close to the ergo edge to avoid piercing the
desktop with the screw. (see fig. 1)
fig 1.
Adhesive pads
(optional. qty 4)
Wood screws
(qty 12)
Front bumper
Back bumper
Wire clip
Acorn nut
(qty 4)
Cord catcher
Mousepad
Mechanism
Track
(11’’ and 21’’ tracks are included.)
Package Contents:
Tray
Wrist support
Track Spacer Kit
(optional. sold separately)
*A note before you begin:
Determine where to mount the Keyboard tray. If you need to mount it
over the Crossbars of your desk AND you ordered the optional Track
Spacer Kit, open the box containing the Track Spacer Kit and follow
those instructions inside.