background image

© UPLIFT Desk

 • 800-349-3839 • [email protected] • upliftdesk.com

Wire tray

(long or short width. qty 2)

3mm Allen wrench

Power block screws

Extension washers

Package Contents

Power & Data Rail: Wire Tray

SKU: PDC005-TRAY

Step 1 - Single Tray

The Extension washers and the screws used to attach the Pow-
er block to the Rail assembly will also be used to attach the 
Wire trays. 
Loosen all four screws of the Extension washers. Then loosen 

the two Power block screws on the side the first Wire tray is 

being attached to. Only loosen these screws enough to slide 
the Wire tray underneath (about two full turns). DO NOT COM-
PLETELY REMOVE THESE SCREWS.
Align the slots of the Wire tray with the Power block screws. 
Then slide the tray underneath both the Power block screw 
heads and the wings of the Extension washers as far as it will 
go. Make sure that the outer lip of the Wire tray is facing up 

towards the top of the Rail assembly and away from the floor. 

Once the Wire tray is in place, tighten the Power block screws 
with the 3mm Allen wrench. If you are going to add a second 
Wire tray to the other side of the Rail, do not tighten the Exten-
sion washer screws yet.

Step 2 - Dual Trays

Once the first Wire tray is in place and the Power block screws 

have been tightened, loosen the other two Power block screws 
about two full turns.  Again, DO NOT COMPLETELY REMOVE 
THESE SCREWS. 
Slide the second Wire tray under the Power block screw heads 

and the Extension washer wings just like the first Wire tray.

Once the second Wire tray is in place, tighten the two Power 
block screws and the four Extension washer screws completely 
using the 3mm Allen wrench.

Reviews: