© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
NOTE
The Small brace’s outer edges flare slightly out. Make sure the
flared side is facing the front of the chair assembly.
If you wish to assemble the kneeling chair so that the Barrel nuts
are hidden, simply insert the Small brace with the empty holes
facing the floor.
Step 3
Insert two (2) Barrel nuts into the holes on the Small brace. Make
sure the notch on each Barrel nut is facing up and perpendicular
to the Rockers.
Thread in the Long screws into the holes on the outside of the
Rockers, and begin tightening. Once all screws from Step 1 and
Step 3 are in place, you can tighten all of the screws all the way.
Step 1
Using the Large brace, connect the right and left Rockers. The
Large brace is wider on its bottom and narrower on the top.
Make sure it is properly aligned. Insert the Large brace’s metal
screw-pegs into the rear holes on the back curve of each Rocker.
Use four (4) Medium screws on these holes from the outside of
each Rocker, and begin tightening with the Allen wrench, but do
not fully tighten until Step 3. This gives you a little wiggle room
to help you install the Small brace more easily.
Step 2
Slide the Small brace between the Legs, lining up the Wood pegs
with the outer two holes.
Large brace
Small brace
Allen wrench
Long screws
(qty 2)
Medium screws
(qty 4)
Small screws
(qty 6)
Wood pegs
(qty 6)
Barrel nut
(qty 2)
Knee cushions
(qty 2)
Seat cushion
front of
assembly
Rocker
(qty 2)
Package Contents
Ergonomic Kneeling Chair
SKU: CHR463
