© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
®
View™ Monitor Arm Instructions
ACC301
There are two ways to attach your UPLIFT View™ Monitor Arm to your desktop: Clamp and Bolt-thru assembly.
Clamp Step 2
Apply the arm gasket (part 2) under the arm’s mount, and the clamp
gaskets (part 5) to the bottom clamp (part 6).
Clamp Step 1
Connect the top clamp (part 3) to the Adapt View™ arm assembly using
the three M6x12mm screws (part C) and the small Allen wrench (part G).
Clamp Step 3
Connect the bottom clamp assembly (part 6) by using M6x10mm (part D)
and the small Allen wrench (part H)
. Affix the Clamp gaskets as shown.
Clamp Step 4
Turn the knobs counterclockwise to loosen them.
Slide the assembly onto your desk and turn the knobs clockwise
to tighten the clamp to the desk.
Make sure that the clamp is secure.
If the clamp is too loose, the unit may wobble or fall.
Snap the cable cover to the back.
Part 1
UPLIFT View™ arm
Part 4
Cable Cover
Part 3
Top Clamp
Part 7
Bolt top clamp
Part 2
Arm gasket
Part 8
Bolt
Part 5
Clamp Gasket
Part 9
Bolt gasket
Part 6
Bottom Clamp
Part 10
Bolt bottom clamp
Part 11
Bolt knob
Part A
M4x12mm screws
(qty 4)
Part F
Washers
(qty 8)
Part B
M5x12mm screws
(qty 4)
Part G
Allen wrench
(small)
Part C
M6x12mm screws
(qty 3)
Part H
Allen wrench
(large)
Part D
M6x10mm screws
(qty 2)
Please select the appropriate
mounting holes according
to the thickness of the desk.
Clamp Assembly -
Attach the arm to the back of your desk
Screws & Tools