© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
Step 3
Place the Tray on top of the Main bracket, lining up the front
and back of the tray with the front and back edges of the desk-
top.
From the underside, attach the Tray to the Main bracket using
four M6x8 Flat head screws, inserting the screws into the four
holes that most closely align with the slots in the bottom of the
Main bracket.
Only tighten each screw a few turns by hand. Once all screws
are in place, push the Tray so it sits flush against the side of
the desktop and using the 4mm Allen wrench, tighten all four
screws.
Once Tray is installed, you can place the black neoprene rubber
Tray pad on top to protect the Tray’s surface. If you would like
the pad to be permanently attached, simply remove the paper
backing from the Tray pad and stick into place.
Package Contents
Step 1
Fit the Main bracket around your assembled UPLIFT Desk
frame.
Choose the side you want the tray to be on, and bring the Main
bracket from below, then fit the slot around the desk frame side
bracket as shown.
Align the two holes on each side of the Main bracket with holes
in the desk frame and attach using the four M8x10 Flat head
screws. Start all screws loosely by hand first, then tighten with
the 5mm Allen wrench.
The Desk Extension can be installed on either the right or left side of your UPLIFT Desk frame. These Instructions apply
to both the UPLIFT Desk C-Frame and T-Frame.
Step 2
If you plan on placing more than 30 lbs. of weight on the Desk
Extension, it’s important to add U-brackets during this step, as
they give additional strength and stability to this accessory.
Line up one U-bracket on the front side of the Main bracket,
fitting the slot around the side bracket on your frame. Attach
using two M6x10 Socket screws and tighten with the 5mm Al-
len wrench. Repeat this step with the second U-bracket on the
other side. Make sure all four screws are securely tightened be-
fore moving on.
Tray
Tray pad
Main bracket
U-bracket
(qty 2)
Support bracket
M8x10 Flat head screw
(qty 4)
#10x5/8’’ Wood screw
(qty 2)
M6x8 Flat head screw
(qty 4)
M6x10 Socket head screw
(qty 4)
Hex nut
(qty 4)
Allen wrench
(4 mm and 5 mm)
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
Desk Extension
ACC036