32
Parameter
Description
Sync with Computer Time
This parameter is available only when
Sync Mode
is set to
Sync with System Configuration
or
Sync with Latest Server Time
.
The system time for synchronization is the time of the local PC.
NTP Server Address
This parameter is displayed only when
Sync Mode
is set to
Sync with NTP Server
.
Enter the IP address of the NTP server.
Update Interval(s)
This parameter is displayed only when
Sync Mode
is set to
Sync with NTP Server
.
It indicates the interval for synchronizing time with the NTP server.
The value ranges from 30s to 3600s.
(2)
Choose
Setup
>
Common
>
Time
and click the
DST
tab to go to the
DST
tab page.
Figure 7-18
DST Configuration Interface
Table 7-7
Parameter Description
Parameter
Description
DST
The options are as follows:
On
Off
The following parameters are configurable only when
DST
is set to
On
.
Start Time
Set the parameter based on actual conditions.
End Time
Set the parameter based on actual conditions.
DST Bias
The options are as follows:
30mins
60mins
90mins
120mins
Set the parameter based on actual conditions.
(3)
Click
Save
to complete the configuration.
5. Server
If the face recognition terminal is used in standalone mode, you do not need to configure server information.
When connected to the intelligent server, the face recognition terminal can upload data including entry/exit
records and captured images to the intelligent server in real time. Follow the steps to configure the intelligent
server:
(1)
Choose
Setup
>
Common
>
Server
and click the
Intelligent Server
tab.
(2)
Under
Intelligent Server 1
, complete the configuration by referring to the table below.
