INSTRUCTION SHEET
U008260
Calloway Bed Headboard King 6/6
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Headboard
1pc
B
Right Leg
1pc
C
Left Leg
1pc
D
Stretcher
1pc
E
Footboard
1pc
F
Slats
5pcs
G
Support legs
10pcs
H
Side Rails
2pcs
Assembly Procedure
: (Please follow the sketches below.)
Step 1:
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2:
Put the Right Leg (B) and Left leg (C) upright down on a soft and smooth surface to avoid
damage or being scratched. Then attach Stretcher (D) with Allen head bolts (1), spring
washers (2) and flat washers (3) using Allen key (4).
Step 3:
Put the Headboard (A) upright down on a soft and smooth surface to avoid damage or being
scratched. Then attach leg from Step 2 with Allen head bolts (1), spring washers (2) and flat
washers (3) using Allen key (4).
Step 4:
Attach the side rails (H) to the headboard (A) and footboard (E) with Threaded bolt (6) Half
moon washer (7), Lock washer (2) and Nut (8) using Wrench (9).
Step 5:
Attach the support legs (G) to slats (F) and then attach slats (F) to Side rails (H) using
Screws (5)
Assembly is now complete.
