Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Table Top
1 pc
B
Leaf
1 pc
C
Mounting Plate
1 pc
D
Shelf
2 pcs
E
Leg
4 pcs
F
Hardware Pack
1 bag
G
Basket
2pcs
H
Leaf Bag
1 pc
Assembly Procedure
: (Please follow the sketches below.)
Step 1:
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2:
Attach the mounting plate (C) to the table top (A) with long bolts (5), lock washers (7) and flat
washers (6) by wrench (4).
Step 3:
Attach two legs (E) to the mounting plate (C) with nuts (8), lock washers (3) and flat washers
(2) by hand.
Note:
Do not full-tighten the nuts (8) until step 7.
Step 4:
Attach one shelf (D) to the middle blocks of the legs (E) with short bolts (1), lock washers (3)
and flat washers (2) by hand.
Step 5:
Attach the 3
rd
leg to the mounting plate (C) with nuts (8), lock washers (3) and flat washers
(2). Attach the 3
rd
leg to the shelf (D) with short bolt (1), lock washer (3) and flat washer (2)
by hand.
Step 6:
Attach the 2
nd
shelf (D) to the lower blocks of the legs (E) with short bolts (1), lock washers (3)
and flat washers (2) by hand.
Step 7:
Attach the 4
th
leg to the mounting plate (C) with nuts (8), lock washers (3) and flat washers
(2). Attach the 4
th
leg to the shelves (D) with short bolts (1), lock washers (3) and flat
washers (2). Tighten all the bolts (1) and nuts (8) by wrench (4).
Step 8:
Turn the table upright. Put basket(s) on desired shelf (shelves). Unlock the table top (A),
remove the leaf (B) and store it in the leaf bag (H) as shown when leaf is not used. Then
lock the table top.
INSTRUCTION SHEET
932/994/995/996-652
Counter Height Kitchen Island
All manuals and user guides at all-guides.com
all-guides.com
