GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
414-964/965
Entertainment
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Right side panel
1pc
B
Left side panel
1pc
C
Lower back panel
1pc
D
Upper back panel
1pc
E
Mending plate
5pcs
F
Top
1pc
G
Shelf
1pc
H
Divider
2pcs
I
Hardware pack
1bag
Assembly Procedure
: (Please follow the sketches below.)
Step 1:
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2:
Fix the right side panel (A) and left side panel (B) to the lower back panel (C) with the Allen
head bolt (1) using the Allen wrench (6). Fix upper back panel (D) onto lower back panel (C)
using Allen head bolts and screw mending plate (E) using screws (4).
Step 3
: Fix top (F) to the upper back panel (D) with the Allen head bolt (1) using the Allen wrench.
Step 4
: Attach the shelf (G) to the side panels (A&B) with shelf support (3) using screws (4).Insert the
magic wires (5) onto the shelf (G) and push dividers (H) into the hutch.
Step 5
: Attach the hutch to the base with mending plates (E) using screws (2).
Note:
It is best two or more persons are involved.
Assembly is now complete.
