Local Expansion Adapter Kits Installation Guide
8
Unitronics
Wiring the Power Supply (UAG-XKPxxx, UAG-CX-XKPxxx, UAG-CX-XKPLxxxx,
or UAG-XKPLxxxx)
These end units require an external 12 or 24VDC power supply.
The 0V of these end units must be connected to the controller's 0V. Ignoring this
directive may damage the device.
In the event of voltage fluctuations or non-conformity to voltage power supply
specifications, connect the device to a regulated power supply.
Connect the +V and 0V terminals as shown in the
accompanying figure.
Removing the Expansion Adapter
1. Turn off the system power.
2. Remove the Power/Earth terminal block from the bottom of the End unit.
3. Disconnect the cable:
Short-Range: Unplug the cable from the RJ45 port on the Base Unit.
Long-Range: Unplug the blue cable from the RJ45 ports of the Base and the End
units.
4. To remove the Base unit:
UAG-XKPxxx, UAG-XKxxx, UAG-XKPLxxxx
Pull the top clip up and the bottom clip down, and pull the unit slowly away until
the plug disengages.
UAG-CX-XKPxxx, UAG-CX-XKPLxxxx, UAG-CX-XKPLxxxx
Pull the unit slowly away until the plug disengages.
5. To remove the End unit:
Locate the Bus connector lock of the Uni-I/O™ module connected to the End Unit
and slide it to the right.
Pull the End Unit’s top DIN-rail clip up and the bottom clip down.
Pull the End Unit out of its place (away from the DIN rail).
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole
discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either permanently or
temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties of
merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information presented in
this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind, or any damages whatsoever arising
out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other
third parties and you are not permitted to use them without the prior written consent of Unitronics or such third party as may own them
DOC20001-F7 07/19
