PROTECTION AGAINST OVERHEATING
−
−
−
An additional fitted safety thermostat protects the
heater against overheating and switches it off
automatically. The service lamp then goes out.
If the device switches itself off, disconnect the mains
plug from the socket. The heater is ready for service
again after a short cooling-off phase (approx.15
minutes). Plug the mains plug back into the socket.
If this repeats itself, first check whether the
thermostat switch is set correctly or if objects hinder
the heating operation.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow
it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp
cloth and buff with a dry cloth. Do not use any
detergents or abrasives and do not allow any water to
enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time, it
should be protected from dust and stored in a clean dry
place.
Note: this appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety. Children should be
supervised to ensure that they do not play with the
appliance.
Note:
When using in timer mode, due consideration
should be given to the fact that the heater may switch
on while unattended.
6
