Page
48
of
54
14.2
Register Clave Headsets
The registration of the Clave Headsets to the VoIP system is done via the
Extensions
page. The procedure
is the same as registering an UH DECT handset. Therefore, please refer to the
VoIP System guide
and follow
the steps for
enabling registration mode
for the VoIP bases. As soon as you have enabled it, follow the
steps below to register the headset.
IMPORTANT:
Due to technical limitations, the Clave Headsets must be free of Clave Base registration before
registering to the VoIP system. This means that the headsets must not be present on the Clave Base when
registering to the VoIP system.
NOTE:
If a headset is registered to the VoIP system and at the same time you register it to an Clave Base,
the connection to the Clave Base will not be stable enough. Therefore, if you wish to have a headset
registered both to the VoIP system and to the Clave Base, we recommend registering the Clave Base to the
VoIP system (refer to
13.1 Register Clave Base
). By doing so, the headset will both support the DECT and
other networks.
NOTE:
When using the headset in standalone mode in the VoIP system, it is recommended to charge the
device via the USB-C cable attached to an adaptor. Else, if connected to the Clave Base or to a PC, the
headset connection might not be stable enough.
Step 1
Power on the headset via the power slider
Step 2
Activate the DECT registration on the headset by long pressing the DECT button on the
headset until the voice prompt announces “Registering”
Step 3
After a while, the headset will register to the VoIP base.
