SYSTEM ARCHITECTURE
The Crystal Screens system is made up of three subcomponents:
•
Touch Display Chassis with IR Frame
•
Stele struts
•
Stele electronics Box/Foot with integrated playback PC
The Crystal Screens System is intended for floor-mounted installations in customer controlled environments. It is not intended for
unattended use in public areas like shopping malls or train stations.
The Touch Display chassis consists of a 3.2mm thick protection glass, a 55-inch diagonal TAMOLED (Transparent Active Matrix
Organic Light Emitting Diode) panel and an infra-red touch metal frame.The IR touch enables a maximum of 10 simultaneous touch
points.
The Touch Display Chassis is securely joined to the Stele, but should never be used as the main load-bearing element as a primary
handle or principal support during transport.
The Stele foot incorporates four M8 mounting points on its underside. Levelling feet are pre-installed in these mounting points in the
Crystal Screens. The feet should be removed if a fixed installation is required. The Stele struts and foot are the part of the system to
use as a primary handhold during transport and mounting.
There are four secondary M8 mounting points on the underside of the Electronics Box for the two transportations plates, which must
be installed prior to transportation in the designated TOLED FlightCase.
The bottom view of the Crystal Screens in the figure below illustrates the levelling feet and the transportation plates.
CRYSTAL SCREEN
TRANSPARENT OLED SYST
EM
© 2017 united
.screens
GmbH
