PROBE BUDDY – USER MANUAL
Page 8 of 27
UPC_MAN013_R7
Copyright © United Process Controls.
All rights to copy, reproduce and transmit are reserved.
1.
SIGNAL DIRECTION ICON
- Changes the signal direction of both the thermocouple and
millivolt signal by pressing the
IN/OUT
key. Left arrow (pointing out) indicates output mode.
Right arrow (pointing in) indicates input mode.
2.
TEMPERATURE
– Display of thermocouple signal is based on the thermocouple type and
temperature scale (°C/°F) selected in the setup menu.
3.
TEMPERATURE SCALE
– Indicates the temperature scale
4.
PROCESS VALUE
– Selected process is displayed here based on the temperature and
millivolt signals, either inputs or outputs. The scale will change according to the process.
5.
RAMP
– Indicates that the selected output signal is ramping from a selected start and stop
range. The ramp function is enabled in the SETUP / OUTPUTS menu. One or both outputs
will ramp if enabled. Changing values are displayed.
6.
PROCESS
– Indicates the selected process: DPT for dewpoint, %C for carbon, %O2 for
oxygen, and PPM for %O2 values below 00.01% oxygen.
7.
SENSOR MILLIVOLTS
– Shows the measured or set sensor millivolt output.
8.
DIGIT CURSOR
– Cursor indicates the digit selected to change. The cursor shifts from
temperature to millivolts when the TC/MV key is pressed. The arrow keys change the
cursor position and digit value. The cursor is only available when the signal output mode is
selected.
9.
BATTERY LOW ICON
– Indicates when the battery power is low and should be replaced.
Standby Mode
The PROBE BUDDY is in standby mode when the display is blank. The unit will turn on when
the Enter key is pressed for 5 seconds. The unit has an adjustable wake state time that can be
selected in the SETUP / DISPLAY / SLEEP MODE SHUTDOW parameters. This setting
