UNITED OFFICE 320246 1901, Operating Instructions Manual, Page: 26 / 102

GB│IE
│ 23 ■ UAVK 180 A1
Troubleshooting
If there is a jam in the appliance
This means that you may have fed too much paper into the appliance (max.
7 sheets 80 g/m2
for manual feeding, max. 75 sheets 80 g/m 2 for automatic
feeding).
During automatic feeding, the appliance will beep until the paper jam is cleared.
During manual feeding
. , the overheat/overload LED 3 flashes continuously
red until the paper jam has been cleared.
♦ Slide the AUTO/OFF/REV switch
!
to the REV (reverse) position if the
material being shredded gets stuck. The appliance now goes into reverse
and the material is ejected.
The
power/bin full LED
-
continuously lights up blue.
♦ Pull the material being cut out of the appliance and then slide the AUTO/
OFF/REV
switch ! to
AUTO
.
The appliance is now ready for use.
If the appliance suddenly stops working
This means that the appliance has overheated and the automatic safety cut-out
has activated. The
overheat/overload LED
3
lights up continuously red.
♦ Slide the
AUTO/OFF/REV
switch ! to the
OFF
position. The
power/bin
full
LED - and the
overheat/overload
LED 3 go out.
♦ Remove the plug from the mains power socket.
♦ Allow the appliance to cool down for about 30 minutes.
♦ Replace the plug in the mains power socket.
♦ Switch the appliance on by sliding the AUTO/OFF/REV switch ! to the
AUTO position. The power/bin full LED - continuously lights up blue. The
overheat/overload LED 3 remains off when the appliance has cooled
down sufficiently.
The appliance is now ready for use.
If the appliance cannot be switched on
♦ Check whether the mains plug is plugged into the mains socket.
♦ Check whether the
overheat/overload
LED 3 has come on. If it has come
on, the overheating protection has been triggered. Proceed as described in
the section “Overheating protection”.
♦ Try a different wall socket.
♦ Make sure the cutter attachment is seated correctly on the waste collec-
tor .
♦ The appliance is possibly defective. Have the appliance checked by a
qualified technician.