- 14 -
© 2022 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered trademarks of their respective owners
MS836B User’s Manual
Enter Setup
Exit Setup
2.6 Wireless 2.4G Setting
2.4G Receiver Mode *
Scan the
“2.4G Receiver Mode” barcode to enter the 2.4G receiver mode
automatically and connect to the receiver which is matched last time by
default.
One scanner pairing to one receiver is the factory default. If you want to pair
with a new receiver, please refer to the following instructions.
Pairing with new receiver
There are two ways to pair with the new receiver:
A.
Scan the “2.4G Receiver Pairing” barcode.
B. Long press the button for about 16 seconds.
A.
Scan the “2.4G Receiver Pairing” barcode
(1) Remove the original receiver.
(2) Scan the following barcode:
(3) Insert the receiver you want to connect with into your device. You will hear a
short beep when pairing succeeds.
B. Long press the button for about 16 seconds
(1) Remove the original receiver.
(2) Long press the button for about 16 seconds. During the process, there will
be 2 sounds respectively; first sound at the 8
th
second, the second at the
16
th
second, then release the button.
2.4G Receiver Pairing
