38
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed between
the transmission of each character of scanned data. Scan the Intercharacter Delay bar code
below, then scan the number of 5ms delays, and the
Save
bar code using the
Programming
Chart inside the back cover of this manual.
To remove this delay, scan the
Intercharacter Delay
bar code, then set the number of delays
to 0. Scan the
Save
bar code using the Programming Chart inside the back cover of this
manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed after the
transmission of a particular character of scanned data. Scan the
Delay Length
bar code below,
then scan the number of 5ms delays, and the
Save
bar code using the Programming Chart
inside the back cover of this manual.
Next, scan the
Character to Trigger Delay
bar code, then the 2-digit hex value for the ASCII
character that will trigger the delay ASCII Conversion Chart (Code Page 1252), beginning on
page 115.
To remove this delay, scan the
Delay Length
bar code, and set the number of delays to 0.
Scan the
Save
bar code using the Programming Chart inside the back cover of this manual.
