106
⚫
Record Delay: System can delay the record for specified time after alarm ended. The value ranges
from 10s to 300s.
⚫
Tour: Here you can enable tour function when alarm occurs. System one-window tour.
⚫
Snapshot: You can enable this function to snapshot image when a motion detect alarm occurs.
⚫
Video matrix Check the box here to enable this function. When an alarm occurs , SPOT OUT port
displays device video output. It displays video (1-window tour) from alarm activation channel you
select at the Record channel item.
⚫
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Please highlight icon
to select the corresponding function. After all the setups please click save
button, system goes back to the previous menu.
Note:
In motion detection mode, you cannot use copy/paste to set channel setup since the video in each
channel may not be the same.
In Figure 3-110, you can left click mouse and then drag it to set a region for motion detection. Click Fn to
switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 3-109
Summary of Contents for EmPower NVR
