UNIS Ultra Moto VR, Operation Manual

Page: 26 / 99

Ultra Moto VR Manual
03/03/2020
25
7. TROUBLESHOOTING
7.1 Common Problem
Please confirm that all connectors fit tightly.
Symptom Possible Cause Recommended action
Game will not start
Frame assembly connector
is loose.
Check connector.
Frame assembly fault Contact with UNIS Service.
Power off
Circuit protector make
power SW in off state.
Turn on power SW again. If appeared
again and again, machine has
anomaly. Please contact with UNIS
Service.
No ticket dispensing
Out of ticket. Add ticket and press reset button
Ticket jamming.
Remove the jammed tickets and press
reset button.
The connector is loose. Plug the connector tightly.
No sound
Low volume Raise the volume.
Connector loose. Check connector.
Speaker fault. Check speaker.
POT installation error. Install POT correctly.
POT fault. Change POT.
Audio cable problem.
Reconnect the audio cable or change
it.
PC crash. Restart or system recovery.
Driver problem Restart the audio driver.
Display black screen
Check connectors. Plug in connector tightly
Display fault.
Utilize another source such as a PC to
verity if the display is operational.
RAM is loose. Remove and reinsert RAM.
Display blue screen
PC power cord is loose Check PC power cord whether is loose.
VGA signal cable is loose. Check VGA cable
PC video card is loose. Reseat video card.
“0X000000A” code
appears. Conflict between
computer drive and
software.
Contact service
The gas, brakes or the tilt
axis function not work.
The gas, brakes or the tilt
axis function fault.
Enter [Main Menu] > [Hardware
Test] >[I/O Test] to run the testing. If
the testing does not respond, contact
your local distributor to replace the
corresponding VR.
Blank screen on VR
headset
VR headset cable is loose.
Reconnect the headset cable or
change it.
Note: After replacing component from pc (except for RAM), and replacing monitor, the
game should be recovered again with the recovery stick attached to the machine.