Unipulse TM700, Operation Manual

Page: 59 / 91

50
5 SETTING OF FUNCTIONS
50
SE
TT
IN
G
O
F F
U
N
C
TIO
N
S
Chapter
5
■
Graph trigger start level
If you select "Continued trigger" or "Single trigger" in the graph function setting, set the graph
trigger start level.
≪
Setting value
≫
-99999 to 99999
How to set
■
Graph trigger slope
If you select "Continued trigger" or "Single trigger" in the graph function setting, set the graph
trigger slope conditions.
≪
Setting value
≫
Either, Rising, Falling, Beyond, Below
How to set
- Either: Starts plotting a graph when the torque crosses the trigger level.
- Rising: Starts plotting a graph when the torque crosses the trigger level from a lower
value to an upper value.
- Falling: Starts plotting a graph when the torque crosses the trigger level from an upper
value to a lower value.
- Beyond: Starts plotting a graph when the torque is greater than the trigger level.
- Below: Starts plotting a graph when the torque is less than the trigger level.
5-15.
Key LOCK
Disables all key operation on the measurement screen
(comparison, graph) while the external input B5
terminal is short-circuited.
SET. Graph Setting Page 1
→ →
Meas. Setting
→
SET. Graph Setting Page 1
→ →
Meas. Setting
→