30
6
Hold Function
30
H
o
ld
Fun
ction
Chapter
6
6-5.
Peak to peak hold
Holds the difference (range) between the peak and bottom values of torque.
- Operation of peak to peak hold (start mode: key)
Holds the input at the
key down as the standard value, and the maximum difference of the
input values as the indicated value.
Press the
key again to confirm.
Press the
key again to stop hold operation.
- Operation of peak to peak hold (start mode: level)
The hold operation starts when the torque passes the start level (from above to below or from below
to above) after pressing the
key. Afterwards, the hold operation continues until the torque
passes the stop level (in the opposite direction of the start level). After the passing the stop level, the
hold data is displayed while monitoring the indicated value to pass the start level.
Press the
key again to stop hold operation.
Time
Standard line
Indicated value = 0
Torque
Indicated value
HOLD display
key input
HOLD
Hold
Detection/hold section
Lights off
fix section
Hold release
section
Flashes
Lights on
Lights off
HOLD
HOLD
HOLD
Time
Torque
Indicated value
Detection/hold
HOLD display
section
Hold fix section
key input
HOLD
Start level
Stop level
Detection/hold
section
Lights off
Indicated value = 0
Hold release
section
(Standard line)
Flashes
Lights on
Flashes
Lights Lights off
on
HOLD
HOLD
