3
1
Outline
3
Out
line
Chapter
1
POWER/ALM lamp (red)
USB communication and power supply status from the AC adapter are indicated.
This lamp lights on during normal operation and lights off shortly when an error occurs to indicate
the status.
Normal: Lights
on
When the PC application is not communicating:
Lights off once
When the AC adapter is not connected:
Lights off twice
Power input connector
The dedicated AC adapter included for the TM200 is connected.
Input power is AC100 to 240V (-15%, +10%), free power supply. Frequency is 50/60Hz.
* Refer to P.4 "Connection of power input connector" for connection.
UTM
Ⅱ
connection connector
UTM
Ⅱ
is connected with the dedicated cable.
* Refer to P.4 "Connection of UTM
" for connection.
USB connector
This part is connected to the PC with the USB cable included.
* Refer to P.5 "Connection of the USB cable" for connection.
1-6.
Procedures for the first-time use
Set up the product following the procedures below.
1.
Connect the AC adapter and UTM
Ⅱ
. Refer to P.4 "2-1.Connection procedure".
2.
Install the USB driver and the dedicated PC application.
Refer to P.6 "3-2.PC preparation".
After installing this USB driver, connect the TM200 and PC with the USB cable.
Hereinafter, use the dedicated PC application to operate the TM200.
3.
Set the sensor type. Refer to P.21 "3-6.Calibration tab" and perform calibration.
Once set, the torque and rotation speed can be checked in the waveform tab of the PC application.
Hereafter, set up the actual load calibration, filter and so on as required.