Unipulse F805AT-BC, Operation Manual

Page: 150 / 202

9.OPTION (Option card required)
135
9-1-10. Output selection input
This input specifies the type of BCD data.
9-1-11. BCD out setting
Operation
1 ）
2
）
Select a desired data update rate and press “OK” to confirm.
Selection 4 Selection 2 Selection 1 Weighing value
Open Open Open Belt speed
Open Open Close Weight density
Open Close Open Feed rate
Open Close Close Load ratio
Close Open Open Feed ratio
Close Open Close Gross weight
Close Close Open Total (upper 4 digits)
Close Close Close Total (lower 5 digits)
MODE OPTION → BCD DATA UPDATE RATE PAGE → →
Data update rate and strobe width:
200 times/sec STROBEwidth approx. 2.5mSec
100times/sec STROBEwidth approx. 5mSec
50times/sec STROBEwidth approx. 10mSec
20times/sec STROBEwidth approx. 25mSec
10times/sec STROBEwidth approx. 50mSec
5times/sec STROBEwidth approx. 100mSec
2times/sec STROBEwidth approx. 250mSec
1time/sec STROBEwidth approx. 500mSec