32
4
Performing Final Discharge Control
32
Pe
rfo
rm
in
g F
in
al D
isc
ha
rg
e
Chapter
4
4-7-2.
Upper/lower limit comparison
Upper limit and lower limit can be arbitrarily
set. Set the target weight for comparison with
upper/lower limit comparison weight.
In addition, set the timing of comparison in
upper/lower limit comparison mode.
<Conditional equation>
External signals are output according to the
following conditions.
- Upper limit output (
HI LIM
lights on)
Lights up when [weight value] > [upper limit
setting value].
- Lower limit output (
LO LIM
lights up)
Lights up when [weight value] < [lower limit
setting value].
4-7-3.
Over/under comparison
Over and under can be set from 0 to 999. Set the
target weight for comparison using final and
over/under comparison weight.
In addition, set the timing of comparison in
over/under comparison mode.
<Conditional equation>
External signals are output according to the
following conditions.
- Over output (
HI
lights up)
ON when [weight value] > [(final + over)]
- Go output (
GO
lights up)
ON when [(final - under)]
≦
[weight value]
≦
[(final + over)]
- Under output (
LO
lights up)
ON when [weight value]
＜
[(final - under)]
[Upper/lower limit] (Setting mode 0-1/0-2)
(Input range: 0 to 99999)
[Weighing function 1] (Setting mode 2-1)
2: Comparison OFF
1: Net weight
0: Gross weight
Upper/lower limit comparison
[Weighing function 2] (Setting mode 2-2)
1: Compare when external
judging input is ON
0: Compare regularly
Upper/lower limit comparison mode
(When comparison OFF is selected, the external
output signals for upper/lower limit and over
accelerated injection will be OFF at all times.)
(Accelerated injection will be compared regularly.)
[Weighing function 1] (Setting mode 2-1)
2: Comparison OFF
1: Net weight
0: Gross weight
Final and over/under comparison
[Weighing function 2] (Setting mode 2-2)
3: Compare when complete output is
ON and hold the weight value.
2: Compare when complete output is
ON.
1: Compare when external judging
input is ON
0: Compare regularly
Over/under comparison mode
Determine the weight to be compared to (final + over) and
(final - under).
(When comparison OFF is selected, the external output
signals for over, under, and go are also OFF at all times.)
(If the weighing mode is set to "1: Sequence mode", the
timing is compared and is held when the complete output is
ON, regardless of the setting of over/under comparison
mode.)
[Over/under] (Setting mode 0-7/0-8)
(Input range: 0 to 999)
[Final] (Setting mode 0-9)
(Input range: 0 to 99999)
Summary of Contents for F701+
Page 1: ...01AUG2020REV 1 03 WEIGHING INDICATOR F701 OPERATION MANUAL ...
Page 149: ......
