35
5
FUNCTION SETTINGS
35
FU
N
C
TI
O
N
S
ET
TI
N
G
S
Chapter
5
5-8.
Digital zero(DZ)
This function forcibly zeros the gross weight. However, the gross weight exceeding the DZ
regulation value cannot be zeroed.
1.
Press the
key once.
2.
The gross weight is zeroed.
If digital zero operation is performed when gross weight > DZ regulation value, gross weight from
which the DZ regulation value is subtracted is displayed. At the same time,
“
”
flashes to give
an alarm of the problem. In such a case, take the following measures.
5-9.
Digital zero clear
This function clears the zero point correction amount by digital zero operation.
By performing this operation, the zero point is brought back to the state in which zero calibration
was registered. Also, "
" if blinking, goes out.
1.
Press the
key while pressing the
key.
2.
The zero point correction amount is cleared.
5-10.
DZ regulation value (setting mode 4-4)
Set the range of zero point correction amount (deviation from the zero calibration point) by digital
zero and zero tracking. If digital zero operation is performed or zero tracking is actuated where the
DZ regulation value is exceeded, "
" blinks to give an alarm.
(Input range/0 - 9999)
5-11.
Gross weight display/net weight display
The F701-P can display gross weight or net weight selectively. Switch between gross weight
display and net weight display with the
key. Each time the
key is pressed, switching
is performed between gross weight display and net weight display alternately. When gross weight is
displayed, "
" goes out, and when net weight is displayed, "
" lights.
The display is as follows: Net weight = Gross weight - Tare weight
The tare weight is determined by tare subtraction. The tare subtraction includes one-touch tare
subtraction and digital tare subtraction.
Measure
Change the DZ regulation value setting, and perform digital zero operation again.
(However, since this is a temporary measure, zero calibration should be performed early.)
Remove weighing residue adhering to the tank, etc.
Check around the load cell (scale) for mechanical contacts.
Summary of Contents for F701-P
Page 1: ...01AUG2020REV 1 07 WEIGHING INDICATOR F701 P OPERATION MANUAL...
Page 11: ...Contents X Contents X M E M O...
Page 116: ......
