Unipulse F600AT, Operation Manual

Page: 27 / 81

4.CALIBRATION
18
4-3. Calibration Setting
4-3-1. LOCK2 (Calibration value LOCK)
Set values relating to calibration are locked so as not to be changed by misoperation.
Cancel the lock before performing calibration.
Alternatives:
［
OFF
］ ［
ON
］
4-3-2. Minimum scale division (Can be omitted if there is no change)
Set the minimum scale division of the indicated value.
Setting range: 001 to 100
4-3-3. Decimal place
Set the decimal point place of the indicated value. Selection can be made from the following.
Alternatives: ［ NONE ］ ［ 0.0 ］ ［ 0.00 ］ ［ 0.000 ］
4-3-4. Zero calibration
Set the zero point in no-load condition.
4-3-5. Equivalent input calibration
Set the rated output value and reading of the sensor.
Rated output value: 0.001 to 3.000mV/V
Rated value: 00001 to 99999
MODE
Twice
［
OPERATION
］ ［
LOCK2
］ → → →
MODE
［
CALIBRATION
］ ［
MIN. SCALE DIV.
］ → →
Once →
MODE
［ CALIBRATION ］ ［ DECIMAL PLACE ］ → → Once → → Once
MODE
［
CALIBRATION
］ ［
ZERO CAL.
］ → →
Once
→
MODE
［ CALIBRATION ］ ［ EQUIV. CAL. ］ → → Once →
About the [BALANCE WGT VALUE] setting
For performing calibration, weight value input can be omitted by setting a weight
value to [BALANCE WGT VALUE] beforehand. [BALANCE WGT VALUE] is ganged
with the weight value inputs of [SPAN CAL.] and [EQUIV. CAL.].