Unipulse F600AT, Operation Manual

Page: 42 / 81

8.GRAPH SETTING
33
■ Graphic mode
Select the method of drawing.
Alternatives: ［ CONTINUITY ］ ［ SINGLE ］ ［ LEVEL ］
□
Explanation of each alternative
［
CONTINUITY
］
Drawing is started by the key , and drawing is repeated until the
key is input.
［
SINGLE
］
Drawing is started by the key , and only one screen is drawn.
［
LEVEL
］
Drawing is started when the drawing weight exceeds the trigger level, or the
key , and only one screen is drawn.
■
Trigger level
Set the graph drawing start level (trigger level) if [LEVEL] has been selected by graphic mode
selection.
Setting range: 00000 to 99999
■ X-axis (time) end point
Set the time to display one screen.The setting range is from 2 sec. to 98 sec. (at intervals of 2 sec.)
The X-axis (time) end point can also be set from the graph screen.
Setting range: 2 to 98 (sec.)
■ Y-axis (load) start point
Set the graph drawing start point. (±00000 to ±99999)
Setting range: ±00000 to ±99999
■
Y-axis (load) end point
Set the graph drawing end point.The Y-axis (load) end point can also be set from the graph screen.
Note) The start point should be smaller than the end point.
Setting range: ±00000 to ±99999
■
Drawing weight selection
Select the weight for drawing.
Alternatives: ［ GROSS ］ ［ NET ］
START
STOP
START
START
In drawing in the discharge mode, an “×” mark is drawn when the net weight
exceeds the following:
［ Final weight – SP1 ］ ［ Final weight – SP2 ］ ［ Final weight - CPS ］