2.CONNECTION
5
2. CONNECTION
2-1. Analog Input/Output Terminals Connection
How to connect
1. Strip 5mm of the covering of the wire to be
connected. The size of connectable wires is from
0.21 to 3.31mm
2
(AWG12 to 24).
Twist the tip to such an extent that it will not spread out.
3. Loosen the screw with a screwdriver to open the
connection hole.
A Phillips screwdriver 3 to 3.5mm #1 in shaft
diameter is recommended. (Precision screwdriver,
etc.)
4. Insert the wire into the connection hole so as not to
let the tip spread out.
5. Tighten the screw with the screwdriver.
0.5Nm of tightening torque is recommended.
6. Lightly pull the wire to make sure that it is securely clamped.
7. Insert the wire-connected plug into the F600AT
body, and tighten the screws (two).
5 mm
Compatible connector : ETB42-07P
Pin No.1
Pin No.7
Loosen.
(Turn counterclockwise.)
Tighten.
(Turn clockwise.)
Pin No.1
Pin No.7
Tighten.
(Turn clockwise.)
Tighten.
(Turn clockwise.)
