17
Operating mode
R e f e r e n c e
G u i d e
RECAll MODE
The recall mode is for viewing the previous
measured tire pressures you stored in UniTire.
Up to 20 sets can be stored and recalled.
To go to recall mode, press the
left
button ( )
from either sequence mode or stealth mode.
The recall screen will show either two or four
tires, listed in the sequence you selected in
setup mode. The first line shows the newest
measurement! When you measure more than
20 sets of tires, the oldest one will be erased
and the new one will be stored. That way you
will never run out of memory, even if you do
not clear the memory!
The screen can show four different sets of tires
and at the bottom you can see which page
you are on, and how many pages there are in
total. This example is showing page 1 out of
a total of 2 pages. The maximum number of
pages is 5.
The pressure values are using the unit selected
in setup mode. The unit is shown in square
brackets at the bottom of the screen.
Navigating the pages is easy. To go to the next
page simply press the
right
button ( ).
If you want to go to the first page, you can
press a little longer on the
right
button (
1
).
If you want to
clear the memory, press and
hold the
left
button (
3
).
To go to either sequence mode or stealth
mode, press the
left
button ( ) again.
Summary of Contents for UniTire
Page 1: ...UniTire Pressure Gauge User Guide...
Page 8: ...8 I n t r o d u c t i o n Examples...
Page 22: ...22...
