12
Operating modes
R e f e r e n c e
G u i d e
TURNING UNITIRE ON
There are three different ways to turn UniTire
on. This way you can jump directly to the mode
you want.
If you press the
right
button ( ) to turn on
UniTire, it will start directly in “pressure mode”.
This is the mode to see the current pressure
like a normal pressure gauge.
By pressing the
left
button ( ) to turn UniTire
on, it will start directly in “sequence mode”.
you use this mode to measure and store the
pressure for all 2 or 4 tires for later recall.
The last way to turn UniTire on is by pressing
both the
left
and
right
buttons (
+
). This
way UniTire will start in “setup mode”. This
is not often used, but you will need to set up
UniTire at least once.
When UniTire starts, it will show the startup
screen like shown above. This screen shows
the software version and the individual serial
number. There are two ways to skip this screen.
If you press one of the buttons when the
screen is shown, it will jump directly to the
mode you selected when turning UniTire on.
Another (easier) way is to press a little longer
on the
left
( ) or
right
button ( ) when you
turn UniTire on. That way UniTire knows that
you want to go directly in the selected mode
without the startup screen.
TURNING UNITIRE OFF
Unitire will turn itself off if no buttons are
pressed and no pressure is detected after a
predefined time set in
HElP MODE
UniTire
do offer a built-in help mode. This is
some screens showing what buttons to press
for each function.
To show the next help screen press the
right
button ( ) and to show the previous page
press the
left
button ( ).
To leave help mode, turn UniTire off.
Summary of Contents for UniTire
Page 1: ...UniTire Pressure Gauge User Guide...
Page 8: ...8 I n t r o d u c t i o n Examples...
Page 22: ...22...
