Page 21
P O W E R I N G T E C H N O L O G Y
Document Number: MS0031-MAN rev. 7
guardian_access_ms31-man-rev7-0521.indd
Chapter 4 Installation Guide
WARNING
There are potential hazards related to installing this power system. It is
important to carefully read and understand the contents of the Safety chapter before
performing system installation.
CAUTION
Make sure sufficient room is left around the system to enable optimal air
circulation and thus prevent the system from overheating. Keep vent openings from
blocking.
The following information should be read before attempting to install the Power System.
4.1 Site Requirements
The site should be suitable and ready for the Power supply. If it is not or you are unsure
about this, contact your supervisor before continuing. Check, using a spirit level, that the site
is level. Adjustment is provided in the cabinet to cater for floors that are not flat or smooth.
4.2 Unpacking
Check that the received equipment is in accordance with the packing list. Ensure that the
cabinet and the equipment have not been damaged during transportation.
Report any parts that are damaged, missing or incorrect. If possible, correct the problem
before continuing.
4.3 Tools
The following tools are required for a safe installation of the system:
• Anti-static hand strap.
•
Socket wrench, insulated.
•
Screwdriver set, flat, insulated.
•
Screwdriver set, torx, insulated.
• Screwdrivers, pozidrive (cross head), sizes 1, 2, and 3, insulated.
•
Torque spanner (for battery connection), insulated.
WARNING
Use only single-ended, fully insulated tools. Shafts of screwdrivers etc.
should be insulated.
CAUTION
Installation in USA / Canada must conform with the requirements in
NEC/CEC.
