Page 16
X100 SERIES
INSTALLATION & OPERATING MANUAL
Manual No. x100-5a
x100-man-Rev5a-0214.indd
11.0 INSTALLATION
The X100 can be mounted in either 19” or 23” racks by using the supplied brackets. Mount
it from the front of the rack using the correct offsets to align with existing rack-mounted
equipment. Once mounted in the rack the following connections must be made with the
unit switched off.
CAUTION: Re-read the Safety Warnings and Precautions in Section 3. All power
should be OFF for the input and output loads before making connections. Connection
of the X100 chassis to frame ground should be made first. If the X100 has been turned
on before installation connections, it should be turned off and given a 5-minute waiting
period for all internal energy storage capacitors to be discharged.
11.1
Input AC Power Connection
A 3-wire AC power line should be connected to the input connectors and adjacent
earht points but not plugged into the AC power source. The line, neutral and ground
connections should be carefully observed when making the AC connections. The
AC line cord should be sized to safely carry 20 amperes AC each, minimum.
MODEL
Vin AC
Vout DC
WATTS
A @ 120Vac A @ 240Vac
RPCP48/22-Z
85-264
54.4
1200
11.8
6.2
RPCM48/15-Z
85-264
54.4
800
7.9
4.1
RPCP24/33-Z
85-264
27.2
900
8.6
4.5
RPCP24/25-Z
85-264
27.2
690
6.6
3.5
RPCP12/50-Z
85-264
13.6
680
7.1
3.7
RPCP12/45-Z
85-264
13.6
600
6.3
3.3
Note: ratings given are at nominal voltage for sizing breakers. Label rating may be greater.
Table 3 - Input Current Ratings
11.2
Checking Outputs
Turn all but one output circuit breakers to the OFF position and/or remove all but one
fuses from the GMT fuse-holder. With no loads connected and without the battery
connected, plug in or connect the AC input cords one at a time to the AC power
source. Be sure to use the correct AC voltage for the rectifier inputs.
Using a volt meter measure the DC voltage reading across the FEED and RTN
terminals of the output that is switched on at the rear of the unit. The voltage should
be approximately 54.4, 27.2, or 13.6VDC (depending on model), which is the factory
setting.
