UNION Instruments GmbH
INCA Analyzer Series
– Instruction Manual
System main menu
Page 29 of 59
4.6
Commands
4.6.1
Change channel
This command is only active for analyzers with more than one channel (multi-channel
analyzer) and allows to request the measurement of a certain channel.
4.6.2
Restart system
This command restarts the system.
Note
The
Restart system
command can also be used to interrupt the calibration
process.
4.6.3
Clear messages
Clear the messages that are stored in the system.
4.6.4
Calibration purge gas
Calibration using purge gas is started.
4.6.5
Calibration gas I
Start the calibration using calibration gas I.
4.6.6
Calibration gas II
12
Start the calibration using calibration gas II.
12
under development
Commands
Change channel
Restart system
▼
Clear messages
Under
Commands
menu, press
▲ and ▼ to highlight
Change channel
and press
MENU
/ .
Press
MENU
/ to execute the command.
Change channel
Press ENTER...
Executing...
OK
