1.
Select the MIG function with the MIG/MMA selector switch.
2.
Select
Standard
using the Standard/Spool Gun selector switch (Inside machine).
3.
Connect the weld power cable to the Negative socket and tighten it.
4.
Connect the earth cable plug into the Positive socket and tighten it.
5.
Connect the welding torch into the Euro Mig torch connection socket on the front panel, and tighten it.
IMPORTANT :
When connecting the torch be sure to tighten the connection. A loose connection can result in the connector arcing and damaging
the machine and gun connector. This damage is not covered under warranty.
(6)
Fit the correct size Knurled drive roller for Gas Less
Flux Core wire
(7)
Place wire onto spool holder - (spool retaining nut is
left hand thread ) Feed the wire through the inlet guide
tube into the drive roller.
(8)
Feed wire over the drive roller into the outlet guide
tube, Push the wire through approx 150mm.
1
2
5
3
4
RAZOR MIG 250 Manual |
13
GASLESS MIG INSTALLATION
