14
Installation set up for MIG Welding with MIG250/350/500 SWF Welder
(1) Select the MIG function with the MMA/MIG selector switch.
(2) Insert the earth cable plug into the required polarity and tighten - negative for gas shielded wires
positive for gas less wires. The weld power cable goes into the opposing negative or positive socket.
With Separate Wire Feeder machines the positive MIG socket is located at the rear of the power source
(3) Plug the welding torch into the Euro MIG torch connection socket on the front panel, and Tighten it.
(4) Connect Gas Line to Gas Regulator and connect the gas regulator to the Gas Cylinder.
(5) Fit the correct type and size drive rollers to the wire feed drive unit
(6) Place the Wire Spool onto the Spool Holder
Snip the wire from the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into
the wire feeder inlet guide tube through to the drive roller.
(7) Feed wire over the drive roller into the outlet guide tube, Push the wire through approx 150mm
.
(6) Place wire onto spool holder. Feed the wire
through the inlet guide tube into the drive roller.
(7) Feed wire over the drive roller into
the outlet guide tube, Push the wire
through approx 150mm.
(8) Fit the correct type and size of drive rollers.
V Groove for Hard Wires. Knurled for Flux
Cored. U Groove for Aluminium.
(1) Set TIG/MMA/MIG selector
switch to MIG
(3) Connect MIG torch
(4) Connect the gas line to the regulator
and connect to the gas cylinder
(2) Connect earth lead to the
negative output terminal and
tighten
