Unimac LXG3000 User Manual Download Page 10

Page: 10 / 18

Cordless 34° Gas Powered Framing Nail Gun

E&OE

Batteries and Battery Charging

Charge batteries before use. • A battery that is new or has not been used for a long period

does not charge to full capacity until after approximately 5 charge/discharge cycles. • Do not

recharge batteries after using them if they are not to be used for an extended period. • Recharge batteries

only as and when required. • If the battery is warm after use, allow it to cool before charging, otherwise it

may not fully charge. • Use only with the batteries and battery charger specified by the manufacturer. •

Batteries can explode in the presence of an ignition source, such as a pilot light. Never use any cordless

product in the presence of open ﬂame. Exploding batteries can propel debris and chemicals. • Do not use the

charger in wet areas or expose it to rain or water. • Ensure that the battery charger electrical cord is not

subjected to damage or stress. Do not operate the battery charger if it has a damaged electrical cord or plug.

• Do not open the battery – danger of short-circuiting and/or explosion. • Do not touch the battery terminals

with metal objects and/or body parts as short-circuit and/or personal injury may result. • For best results,

charge batteries in temperatures between 7°C (45°F) and 40°C (104°F). • Dispose of non-serviceable

batteries in an environmentally responsible manner and according to local regulations. Charging time varies

for different battery types depending on battery capacity and charger output etc. • To prolong battery life,

avoid leaving the battery pack on charge for extended periods (over 30 days without use). • During charging,

the battery may become warm and some noise may be emitted – this is normal.

Charging

Generally, if the tool stops during use, or the tool fan slows considerably, it indicates

that the battery needs charging. The tool includes a battery status indicator (

) on the

handle (battery must be inserted into the tool for the indicator to function):

•

Green Flash

– The battery has sufficient charge for normal use.

•

Green ON

– Tool in use.

•

Red Flash

– Battery requires charging.

•

Red Fast Flash

– Tool fault detected.

The battery charger has charge status LED indicators:

•

Red ON

– Charging.

•

Green ON

– Battery charged.

1.  Insert the battery into the charging dock.
2.  Connect the charging dock to the transformer.
3.  Plug the battery charger power supply into an electrical outlet

and switch on. The battery charger indicator LEDs will indicate

battery charge status. Charging takes approximately 2 hours

from fully discharged.

4. When the battery is fully charged, unplug the charger from

power supply and remove the battery from the charging dock.

Inserting and Removing the Battery

Insert the battery (

) into the back of the magazine until it "clicks"

into place.

To remove the battery, press and hold the lock button (

) down

and simultaneously pull the battery from of the tool.

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC `

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC