23
7.
Battery Replacement
WARNING
To avoid electric shock, disconnect the probes
before opening the battery cover and do not connect
to any circuit under test or input signal.
Only replace batteries of the same model or
electrical specification
.
If the undervoltage symbol, "
", appears, it means that the battery
is low (the deviation of the measured value in this state is greater) and
needs to be replaced. Please follow the steps below:
1. Disconnect the probe from the circuit under test.
2. Turn the function range switch to "OFF" and remove the probes from the input
jack.
3. Unscrew the screws on the battery cover with a screwdriver and
remove the battery cover.
4. Take out the 3 used batteries and replace them with 3 new 1.5V SIZE
AAA batteries.
5. Cover the battery cover and tighten the screws.
Summary of Contents for C6
Page 1: ...1 C6 TRMS Digital Clamp Meter 600AAC V1 0 29 11 2022...
Page 2: ...2...
Page 26: ...26...
Page 27: ...27...
