Appendix E: Firmware Update Procedure with Quartus Prime
48.
Connect to the UCD-422 Unit
Power on the UCD-422.
Connect UCD-422 with a USB cable to the PC through
Programmer
connector.
(Pls refer to page 7)
The programming interface is the Ethernet connector in the UCD-422 unit. The PC can be
connected to the UCD-422 unit either through a network HUB or directly.
Please follow either of the two procedures below.
Connecting Through Ethernet Network (Alternative 1)
Connect UCD-422 though
Ethernet
connector to the same network HUB where the
programming PC is connected.
Connecting with Direct Ethernet Cable (Alternative 2)
In case of direct connection, the PC needs to be configured to be an Ethernet network host
by enabling WIFI network share (The WIFI network will not be used for programming).
Connect UCD-422 directly to the PC though
Ethernet
connector;
Enable
WIFI
Internet access of the PC.
From Network and Sharing Center click on the WiFi connection
In Wi-Fi Status dialog click
Properties
and select
Sharing
tab
Select
Allow other network users to connect through this computer’s Internet connection
Click
OK
and
Close
.
Note
The network sharing is shown above for Windows 10. Similar controls can be found
for other Windows versions and other operating systems.
