General
System Security Settings
Figure 6: The Password Policy Page
4)
Select password policy.
5)
Click “Activate”.
It is also possible to select previous or factory default settings.
System Security Settings
Security settings, such as not allowing HTTP and FTP access, disabling NETBIOS and increas-
ing the security by using Certificates might be needed if required by the customer.
Web Access Security settings
When secure mode is enabled, only secure access via HTTPS and FTPES is allowed. HTTP is
automatically redirected to HTTPS and FTP access is not allowed.
The web access security level can be set as follows:
1)
Click “Configuration” on the start page.
2)
Select Other Settings > Advanced Configuration in the menu in the on the Configuration
page.
3)
Select “Web Access” under Security in the menu on the Advanced Configuration page
Figure 7: The Web Access Security Page
4)
Select if Secure Mode shall be enabled or not.
A31003-M2000-M105-01-76A9, 29/06/2020
Wireless Service Gateway WSG, Administrator Documentation
15
