Administration
A31003-D3000-M100-02-76A9, 11-2013
178
OpenScape Desk Phone IP V3R3, Phone Administration, Administrator Documentation
Multiline Appearance/Keyset
The
Address
(Address of Record) parameter is the phone number resp. SIP
name corresponding to the entry in the SIP registrar at which the line is to be
registered.
INFO:
For the configuration of line keys, the use of the DLS
(Deployment Service) is recommended. For operating the DLS,
please refer to the DLS user’s guide. Alternatively, the web
interface or the local menu can be used. Note that the creation of
a new line key and the configuration of some parameters can not
be accomplished by the phone’s local menu.
Generally, it is advisable to restrict the user’s possibilities to
modify line keys. This can be achieved solely by the DLS. For
further instructions, see the
DLS Administration Guide
.
The
Realm
, a protection domain used for authenticated access to the SIP server,
works as a name space. Any combination of user id and password is meaningful
only within the realm it is assigned to. The other parameters necessary for
authenticated access are
User Identifier
and
Password
. For all three param-
eters, there must be corresponding entries on the SIP server.
The
Shared type
parameter determines whether the line is a shared line, i. e.
shared with other endpoints, or a private line, i .e. available exclusively for this
endpoint. A line that is configured as primary line on one phone can be configured
as secondary line on other phones.
INFO:
Shared lines are not available if System > Registration >
Server type (see
3.5.7 SIP Registration
) is set to "HiQ8000".
When
Allow in overview
is set to "Yes", the line will be visible in the line overview
on the phone’s display.
INFO:
Line overview can be enabled or disabled under System >
Features > Feature access (see
Feature Access
).
If a line is configured as hot line, the number indicated in Hot warm destination is
dialed immediately when the user goes off-hook. This number is configured in the
User menu under Configuration > Keyset > Lines > Hot/warm destination. To
create a hot line, Hot warm action must be set to "hot line". If set to "Warm phone",
the specified destination number is dialed after a delay which is defined in Initial
digit timer (seconds) (for details, see
Initial Digit Timer
). During the delay period,
it is possible for the user to dial a different number which will be used instead of
the hot/warm line destination. In addition, the user will be provided with a dial tone
during the delay period. With the setting "No action", the line key will not have hot
line or warm line functionality.
Data required
•
Key label <n>
: Set the label of the line key with the key number <n>.
Default: "Line"
