Calling
23
Calling
Incoming Call
The flashing LED, accompanied by a ring signal and/or a vibrating handset signals a call. Ring sig-
nal and vibrator can be disabled, see "Sound and Alert Settings" on page 48. The calling party’s
handset information or name is shown. The local phonebook name is displayed if the calling par-
ty’s handset number is stored in the local phonebook, else the calling name or calling number is
shown.
Other answering keys and methods can also be set in the Settings menu. For example, it is pos-
sible to set the answering behavior to any key (with exceptions). The answering methods are; Au-
tomatically, Loudspeaking, and Quick answer.
When “Automatically” is enabled, all incoming calls are connected automatically. At “Quick an-
swer”, the call is connected by lifting the handset out of the charger. See "Answering" on page 53.
Answer a Call
When the signal sounds, press
, “Accept” on the left soft key, or press
to answer the call in
loudspeaking mode. The name/number of the calling party is displayed, if calling line information
is available.
Secure voice transmission
If you call a party or receive a call from a party over a secure connection, the “Secure call” icon
, appears up left in the display. A non-secure call transmission is indicated by the “Non-secure
call” icon
.
End a Call
A press on the End key
or the right Soft key “End” ends the call. The duration of the call is
shown in the display.
When a headset is connected to the handset, the headset button can be used to answer the
call. In addition, it is possible to configure the headset button with a specific function, such
as dial last called number, or dial a predefined number. Please contact your administrator to
get support.
The secure voice transmission must be activated by the administrator.
