Unified Brands Randell DPM Series, Operator'S Manual

Page: 9 / 26

unifiedbrands.net 9
Unit Installation
SELECTING A LOCATION FOR YOUR NEW UNIT
The following conditions should be considered when selecting a location for your
unit:
1.
Floor Load: The area on which the unit will rest must be level, free of
vibration, and suitably strong enough to support the combined weights
of the unit plus the maximum product load weight. All casters must be
in contact with the floor to support the weight. Casters may require
shims in order for the caster to be in contact with the floor.
NOTE: If there is a question pertaining to weight load limits, consult the
factory at 1-800-621-8560.
2. Ventilation: The air cooled self contained unit requires a sufficient
amount of cool clean air. Also, avoid locating in an unheated room or
where the room temperature may drop below 55° F (13 °C) or about
86°F (32°C).
INSTALLATION CHECKLIST
After the final location has been determined, refer to the following checklist prior to
start-up:
1. Check all visible components for any potential damage
2. Check that the condenser and evaporator fans rotate freely without
striking any stationary members.
3. Check all doors for proper alignment and seal.
4. Power up unit once plugged in.
5. Allow unit time to cool down to holding temperature.
6. Refer to the front of this manual for serial number location. Please
record this information in your manual on page 3 now. It will be
necessary when ordering replacement parts or requesting warranty
service.
7. Confirm that the unit is holding temperature.
8. Allow your unit to operate for approximately 45 minutes before putting
in food to allow interior of unit to cool down to storage temperature.
NOTE: All motors are oiled and sealed.
NOTE: FAILURE TO FOLLOW INSTALLATION GUIDELINES AND
RECOMMENDATIONS MAY VOID THE WARRANTY ON YOUR UNIT.
ELECTRICAL SUPPLY: The wiring should be done by a qualified electrician in
accordance with local electrical codes. A properly wired and grounded outlet will
assure proper operation. Please consult the data tag attached to the compressor
to ascertain the correct electrical requirements. Supply voltage and amperage
requirements are located on the serial number tag located on the rear interior wall. .
NOTE: It is important that a voltage reading be made at the compressor
motor electrical connections, while the unit is in operation to verify the
correct voltage required by the compressor is being supplied. Low or high
voltage can detrimentally affect operation and thereby void its warranty.