Find Handset
To locate the handset, press
[find]
on the base. The handset will beep for 60 seconds.
The beeping will stop when any handset key is pressed, when it is returned to the base,
or when
[find]
is pressed. The handset will also stop beeping automatically when an
incoming call is received.
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed
to eliminate functions in order to save power. If the phone is not in use, the
talk
/
batt low
LED flashes when the battery pack is low.
If the phone is in use, the
talk
/
batt low
LED flashes and the handset beeps. Complete
your conversation as quickly as possible and return the handset to the base for charging.
NOTE:
• Even when the battery pack is not being used, it will gradually discharge
over a long period of time. For optimum performance, be sure to return the
handset to the base unit after each telephone call.
• Dial mode setting, last number dialed and numbers stored in memory
locations are retained for up to one minute while you replace the battery
pack.
Cleaning the battery charging contacts
To maintain a good charge, clean the charging contacts on
the handset once a month.
To clean, dampen a cloth with plain water and gently rub
the cloth over the charging contacts until all visible dirt is
removed. Dry the contacts thoroughly before returning the
handset to the base.
Caution: Do not use paint thinner, benzene,
alcohol, or other chemical products. Doing so may
discolor the surface of the telephone and damage
the finish.
Tone Dialing Switch-over
If your telephone company requires pulse dialing, you can
temporarily switch over to tone dialing after the call connects. This
feature is useful when you need tone dialing to use any automated
menu systems, such as telephone bank tellers, telephone
prescription refills, customer support menus, etc.
If your phone is set to pulse dialing mode, make your call normally.
Once your call connects, press
[
/
tone]
. Any digits you enter from
then on will be sent as tone dialing. When this particular call ends,
the phone automatically returns to pulse dialing mode.
Summary of Contents for 4541
Page 1: ......
