Page 18
Version 3.3 / November 2016
Figure 23
Figure 24
Figure 25
Figure 26
Figure 27
Figure 28
Filling the ingredient containers
The ROSSO vending machine has 4 containers for
powdered ingredients (see figure 27), whereas ROS
-
SO INSTANT has 5 containers.
To fill the containers, just pick the lid off the container
and fill it from the top (see figure 28).
ATTENTION: Please make sure that no foreign ob-
jects go inside the container during refill. Also make
sure that the ingredients are not compacted (lumped)
during refill.
Please remove the excess of ingredients from the out-
er walls of the containers and other parts of the vend-
ing machine.
There is a reducer-motor behind each of the containers, which is used
to feed the ingredients into the mixer.
The quantity of the ingredient is fixed in the drink’s recipe. The quantity
means the time of rotation of motor, which is installed behind the contain-
er, in tenths (1/10) of seconds.
If needed (for convenience in refilling the containers) the containers
can be removed:
Turn the spout upwards and slightly raise the container with the help of
the spout to ensure that the container’s bottom is free of the holder. Then
pull the container out.
The sugar container is located near the cup dispenser (see figure
3.4.4). This container should be refilled in the same manner as the other
containers (see above).
3.4.5 Cup dispenser
The cup dispenser is fitted on a swinging bracket. The dispenser can hold
up to 600 cups in 5 tubes (see figure 29). The dispenser sequentially re
-
leases cups from all tubes.
Filling the vacant tubes with cups (see figures 31а, 31b):
•
Turn OFF the vending machine
•
Remove the dispenser’s upper lid
•
Load the cups (bottom down) only in the tubes, which are not (even
partially) above the dispensing cavity
Figure 29
Container
for sugar
Cup dispenser
Spoon dispenser
The mechanism of
the dispenser cup