UC-08-M31 EN P1.0.3
Debug Support
15
The UM982-EB has copper exposed on the bottom of the UM982 module, which not only
enhances heat dissipation, but also provides a large area for grounding and is convenient
to test.
U1B
UM982
Figure 6-3 UM982 Pads (Y1-Y39) and Socket Mounting Holes (X1-X8)
7
Debug Support
As mentioned above, TP1 and TP10 can be used to connect an external power to supply
VCCIN and V_BCKP and to measure the supply voltage and current.
TP2, TP4, TP6 and TP8 are used for internal debugging, of which TP6 and TP8 can be
used to debug I
2
C.
J1 and J2 are used for MMCX connection. After soldering the MMCX connector, it can be
used to measure the PPS signals.
J3, J4, J8 and J9 are debug ports. Connect the signal that needs to be tested to the square
hole and test the round hole, or connect the round hole to a measuring instrument. Using
these debug ports can avoid damage to the PCB pads and traces, which is convenient for
debugging.
Summary of Contents for UM982-EB
Page 24: ...Assembly Top of UM982 EB...
Page 25: ...Assembly Bottom of UM982 EB...
