6
Hot surfaces
Risk of burns caused by contact with hot
surfaces:
- steam pipe,
- hot water pipe,
Comply with the safety standards at work!
Repairs
Attention
It is not allowed to carry out repair work on
parts with technical safety function. Replace
the faulty parts with original Unical spare
parts only.
Additional components, spare parts and parts
subject to wear
Attention
Spare parts and pieces subject to wear
that were not tested with the system can
jeopardise its operation. The installation
of parts not approved and unauthorised
modifications may compromise safety
and affect the warranty rights. For the
replacement, only use original Unical spare
parts.
Draining boiling water
Attention
Purge and desalination water can reach
temperatures of 100°C and more.
Before being conveyed to the sewage
system, it must be cooled to a temperature
of < 35°C.
Safety Guidelines
If there is a risk of imminent damage,
decommission the appliance immediately.
In case of serious damage to the feed water tanks, immediately
inform the authorised inspection body before carrying out
repairs.
Comply with the technical instructions.
Access to the boiler room is forbidden to unauthorised
personnel.
Keep the boiler room clean, well lit and, above all, free from
foreign objects that obstruct the operation.
During operation, keep the prescribed exits open and free.
Immediately report any visibly phenomena on welding seams,
not-hermetic damaged points or with first signs of rust, unusual
behaviour of the operating equipment and system components,
anomalous noises inside the boiler.
System faults and defects that cannot be eliminated must be
equally reported to the manufacturer.
All boiler components and adjustment devices must be
protected against rain, water and steam leaks. Any damage or
leaks must be immediately repaired.
