Unical KONf 115, Installation And Servicing Manual

Page: 16 / 40

16
3.5 -
LOCATION OF BOILER INSIDE A
BOILER ROOM
Rispettare le minime distanze di ingombro
per poter eseguire le operazioni di nor-
male manutenzione e pulizia.
The boiler must be installed in accordance with the directions
indicated in the most recent Standards and legislations regar-
ding boiler rooms, installation of heating and hot water systems,
boiler ventilation, chimney’s capable of discharging the products
of combustion of condensing boilers and any other applicable
requirement.
The boiler will be placed on a flat and sufficiently strong base-
ment, with dimensions not smaller than the ones of the boiler.
After installation the boiler will result perfectly horizontal and
very stable ( in order to reduce vibrations and noise).
Installation
When choosing the installation place, the following items have
to be considered:
- To grant an easy access to the boiler components in order to
facilitate the ordinary and extraordinary service operations.
-
The floor should not be of flammable material.
If the floor is flammable an insulation material
- If the floor is flammable an insulation material, with the ca-
pacity to withstand to the fire for at least 120 min should be
placed between the boiler and the floor and will protrude de
boiler basement of 0.5 m all around.
The casing front panel is hinged on the R.H. side.
The hinges ‘’A’’ are factory fitted on the R.H. side
of the frame. For the introduction of the cocker
remove the precut disk ‘’B’’ with a screwdriver
and fit the cocker as shown in the figure.
In case the casing front panel needs to be hinged on the L.H.
side, deplace the hinges
‘’A’’
from R.H. to L.H. side; then re-
move the precut disk ‘’C’’ from the front panel and fit the locker
as shown in the figure.
Mounting of the locker
Mounting of the adjustable feet
Before positioning the boiler, screw down the
adjustable feet supplied with the boiler.